Box dimensions and weight: Single rod size 27X11.5x9.3CM, weight 495 grams, with packaging box size 30.5X12x13cm, weight 560 grams.One box contains 40 single rods, the weight is 22kg and the dimensions are 56.8x54x38.5cm. The set includes a fishing rod + 21 accessories plus a packaging box Weight 710 grams, dimensions with packaging box 30.5x12x13cm Tutorial on the details of rod casting: 1. When preparing to cast, you need to [hold down the trigger in advance] without releasing it, and [simultaneously] release the trigger when throwing, and the line will follow. 2. Note: Holding down the trigger will not release the line; the line will only be released when you let go. Be sure to release the trigger at the same time as you throw it out. 3. The reel is used for reeling in the line. When casting the rod, keep the hook about 10cm distance from the rod tip, and make sure the lead sinker is attached, so you can throw it farther.Throwing from the air can easily result in the line getting stuck or not coming out.Just adjust the five-star linkage a few times (the five-pointed star shape next to the wheel is the five-star linkage). The five-star linkage can be adjusted and twisted either clockwise or counterclockwise Common Problem-Solving Tutorial: 1. If the line cannot be retracted, it means the drag valve is not tightened. The five-pointed star next to the crank wheel is the drag valve. Tighten the drag valve towards the tip of the rod. While tightening, make sure the crank wheel is not rotating. If it still doesn't work, disassemble it and check if the spring inside has come out. Reinstall it and it should work.Or maybe the wire is knotted.Re-launch 2. If it still doesn't work, it may be that the lead sinker is not properly attached, and there is no tension in the front. You can use your hand to pull the line outwards to tighten it, and then you should be able to retract the line normally. 3. Changing the line: Turning the silver wheel hoop to the right can open the fishing rod's spool cover, which is needed when changing the line.When changing the line, the fishing line ties itself into a knot, preventing it from unraveling when the line is used up 4. Solution for the fishing rod's joint locking up (Please try releasing the line in the actual situation; forcefully casting in dry conditions will cause it to lock up) 01、If a fishing rod is stuck at a joint, disassemble the rod and find a flat area where the stuck sections are. Place several layers of thin cloth on top, hold the stuck sections tightly with your hand, and give the ground a few strong impacts. Pay special attention to keeping the rod body vertical during the impact; the stuck part of the rod will then loosen. 02. Place the two stuck sections of the fishing rod flat on the table, use a hair dryer to repeatedly blow on the stuck section (the thicker part), and when you feel the stuck section of the fishing rod is slightly hot to the touch, gently turn it with force to unscrew it. Our store is an authorized dealer of the Weizao brand, and can be authorized by distributors on all major platforms The details of the accessories are shown in the figure below: Oxford cloth storage bag 14-piece accessory set, 6-piece accessory set details: (fishing float, fishing hook, bell, scissors, lead sheet + lead sinker, fish feed) 21-piece accessory set (frog + fake fish) 21-piece accessory set (2 fake fish) Details of the 12-piece accessory set: