A cap is the smallest item in your pack and the one that decides whether a long ascent is tolerable. On an exposed ridge it shades your face, ears and neck for hours; on a cold summit it stops heat escaping through your head. Most walkers own one cap and use it in conditions it was never designed for.

This guide covers which cap suits sun, wind and rain, how brim width and fabric protection work, why packability matters more than weight on a day hike, and how to get a fit that still works when you put a waterproof hood over it.

Sun protection on exposed ground

UV exposure increases with altitude, and it increases again over snow, water and pale rock, all of which reflect light back at your face. A day on an open ridge can deliver more UV to your skin than a day at the beach, without the heat that reminds you to do something about it.

The NHS sun safety guidance makes the point that covering skin is more reliable than sunscreen alone, and that damage accumulates over years. For regular walkers, a cap with real coverage is a practical health measure rather than an accessory.

Brim width and coverage

Style Coverage Best for
Baseball cap Face only Woodland, short walks, under a hood
Bucket hat Face and ears, short rear brim General hiking, changeable weather
Wide-brim sun hat Face, ears and neck Exposed ridges, summer, glacier approaches
Legionnaire / neck-flap cap Full neck coverage Strong sun, long days above the treeline
Beanie or watch cap Warmth, no shade Cold summits, winter walking

A 7–8 cm brim shades the face; 10 cm starts to shade the neck. Below about 6 cm, a brim is styling rather than protection. If you walk in strong sun regularly, a wide brim plus a neck gaiter covers what a cap alone cannot.

Fabric, UPF and colour

UPF 50 fabric blocks roughly 98% of UV radiation, but the rating applies to a dry, unstretched fabric. Once a cap is soaked with sweat, the protection drops. Dense woven nylon and cotton hold their rating better than loose knits.

Light colours reflect heat and stay cooler in direct sun. Dark colours absorb heat but hide sweat and dirt. On a long summer ascent, light colour plus real coverage beats a dark cap with a small brim every time.

Comparison of a baseball cap, bucket hat and wide-brim sun hat seen from the side on a grey surface, studio light, no people

Cold, wind and altitude

Above the treeline, wind is the dominant problem. A cap with no insulation does nothing in cold wind, and most heat loss through the head happens at the ears and neck rather than the scalp.

  • Carry a lightweight beanie even in summer on high routes. It weighs almost nothing and changes a cold summit from unpleasant to manageable.
  • Cover the ears. A cap leaves them exposed; a beanie or a cap with ear flaps does not.
  • Add a neck gaiter. It seals the gap between collar and hat, which is where wind finds skin.
  • Avoid cotton beanies. They hold sweat and stop insulating when wet.

The Met Office guidance on wind and wind chill is worth checking before an exposed route — wind chill is what makes a summit feel ten degrees colder than the forecast.

Rain and hood compatibility

In rain, the cap has one job: keep water off your face and out of your eyes. A brimmed cap under a waterproof hood does that far better than a hood alone, which tends to press against your forehead and drip onto your glasses.

  1. Choose a thin crown. A bulky cap lifts the hood and creates a gap at the back of your neck.
  2. Check the hood has room. Try the combination before you leave, not on the ridge.
  3. Prefer a brim you can see past. You need peripheral vision on scree and near edges.
  4. Skip the wide brim in high wind. It acts as a sail; a narrower brim or a beanie is safer.
A hiker-free still life of a cap and waterproof jacket hood on a rucksack at a mountain trailhead, low cloud, no people

Packability and weight

Most hiking caps weigh between 50 and 120 g. That is light enough to carry two: a sun cap for the ascent and a beanie for the summit. The bigger factor is packability — a structured wide brim that cannot be folded is awkward in a small day pack.

Look for a brim you can fold, a cap with a soft crown, or a hat that survives being crushed at the bottom of a pack. A cap you leave at home because it takes up space is the least useful item you own.

Care and lifespan

  • Hand wash and air dry. Machine washing collapses brim structure and reduces UPF performance.
  • Rinse sweat out after every walk. Salt stiffens fabric and shortens the life of the brim.
  • Store flat or folded as designed. A crushed brim never fully recovers.
  • Replace when the brim loses shape — coverage and protection go with it.

A cap handles the top of you; the rest of the outfit decides the day. Our zip-off walking trousers guide covers legwear that works across two climates, and the outdoor accessories range covers gaiters, gloves and neckwear. The camping and hiking range has the rest.

FAQ

What is the best cap for hiking in summer?

A wide-brim hat with at least 7 cm of front brim and rear coverage. Add a neck gaiter on exposed routes above the treeline.

Should I wear a cap under a waterproof hood?

Yes in rain — a brimmed cap keeps water off your face and glasses far better than a hood alone. Choose a thin crown so the hood still fits.

Is a baseball cap enough sun protection?

It protects the face but leaves the ears and neck exposed, which is where most sunburn happens on a long walk.

Do I need a separate beanie for cold weather?

Yes if you walk above the treeline or in winter. A lightweight beanie adds little weight and covers the ears, which a cap does not.

How much does a hiking cap need to weigh?

Typically 50–120 g. Packability matters more than the difference between them: a cap you actually carry is better than a lighter one left at home.

Sources